Skip to content

The report

The report is the customer’s record of the visit and the basis for the certificate, the quote and your company’s purchase order. It’s filled in on site, on the phone — there’s no paperwork afterwards.

Press Finish job. The app shows your time on site and asks to confirm, then asks how the visit went.

The Finish this job sheet showing time on site
Your time on site, as recorded.
The How did the visit go sheet with four outcomes
One outcome. It decides what happens next.

Pick one:

OutcomePick it whenWhat happens
FixedThe issue is resolved on site.Job complete. Certificate if it’s that kind of job.
No issue foundYou attended, nothing wrong.Job complete.
Revisit requiredParts needed, you must come back.Your manager builds a quote; the customer decides.
AR / IDAdditional repair or further investigation needed.As above — a quote.

Nobody home is not on this list. That’s its own path: No access.

Next comes the to-do list for this job. A repair has one item; a gas safety or service job has two.

The Wrap up this job screen with two sections to do
Both have to be done before you head off.

Job report is below. Gas safety record (CP12) is the certificate.

  1. Attendance. Your arrival and departure times, taken from when you pressed I’m here and Finish job, and the outcome you picked. Check them and press Continue.

  2. Fault details. What you found and what you did, in plain words — the customer reads this. Both are required. Under each box, Rewrite with AI tidies what you’ve typed into full sentences; it never invents anything you didn’t write. Then the appliance make and model.

  3. Coverage questions. A short Yes/No set for this category — whether the make and model were on site, whether a drain-down was needed, whether sludge or corrosion caused it, and so on. These decide what the customer’s cover pays for, so answer them honestly.

  4. Photos. Before, after, and the boiler data sticker are required. A job video is optional, thirty seconds at most.

  5. Review and submit. Everything on one screen. Check it, then Submit report.

Step 1, confirming attendance times and outcome
1/5 — times and outcome.
Step 2, fault description and actions completed
2/5 — what you found, what you did.
Step 3, the coverage questions
3/5 — the coverage questions.
Step 4, the photo list
4/5 — before, after, data sticker.
Step 5, review and submit
5/5 — check it, then submit.

Submit report sends it to PlusHeat, to your manager’s Books, and — for a gas safety or service job — on to the certificate.

Fill it in anyway. The app keeps everything on the phone and sends it the moment you have signal — you can drive off and it goes on its own. Photos too. Don’t delete them from the phone until the job shows as done.